Lexicon DC-1 User Manual download pdf (Page 54)

Lexicon

DC-1 Effects

Parameter Initial Value Range

ROLLOFF 3.3kHz 453Hz to 20.0kHz

ACADEMY FILTER ON ON/OFF

MAIN LEVEL 8 0-16

SUBWOOFER LVL +0dB -5 to +5dB

EFFECT LEVEL -04dB -30 to +05dB

CUSTOM

Mono Logic

Mono Logic takes a monaural soundtrack and sends music and sound

effects to the sides and rear through a room simulator mode while keeping

the dialog in the center.

Mono Logic Parameters

ROLLOFF regulates the treble cut in the side and rear channels. The optimal

setting for this parameter will vary widely with the age, quality, and

condition of the source material.

ACADEMY FILTER is provided to recreate the proper tonal balance of

older monaural films that were recorded with much narrower and duller

frequency response than current films.

MAIN LEVEL controls the level of the mono signal that is reproduced by the

main speakers. When a center speaker is part of the configuration many

films may sound better when this control is set between 6-12. This spreads

the film sound out around the screen and can be more pleasant than

restricting the dialog and much of the other film sound to the center speaker.

SUBWOOFER LVL boosts or cuts the subwoofer output level. Although the

normal subwoofer level is set during the calibration procedure, with some

recordings it may be desirable to increase or decrease this deep bass level.

EFFECT LEVEL adjusts the loudness of the side and rear speakers. When

there are no side speakers, it adjusts the amount of ambient signal mixed

into the main loudspeakers.

1 2 ... 49 50 51 52 53 54 55 56 57 58 59 ... 75 76

No comments

Lexicon DC-1 User Manual Page 54