Lexicon MC-12 User Manual Page 27
- Page / 194
- Table of contents
- BOOKMARKS
Rated. / 5. Based on customer reviews
Basic Operation
Lexicon
2-10
Rear Panel Overview (continued from page 2-9)
Note:
The numbered items below correspond with the rear
panel illustrations on pages 2-6 and 2-8.
13.Trigger Output Connectors
Provide 12V DC output to control connected components.
Three trigger output connectors are available on a removable
terminal block. The connector labeled PWR – the power trigger
output connector – is not configurable. It is activated when the
MC-12 is activated, and deactivated when the MC-12 is
deactivated. The trigger output connectors labeled 1 and 2 can
be configured for remote or program operation.
14.IR IN Connector
Accepts input of IR signals from infrared distribution equipment.
One 3.5mm jack that accepts a stereo plug (Tip/Ring connection)
or mono plug (Tip/Sleeve connection) is available.
15.Microphone Input Connectors
Provide microphone input for speaker distance and output
level calibration. Four 3.5mm Tip/Ring/Sleeve connectors are
available.
16.Removable Access Panel
Accommodates connectors for emerging technologies.
REMOTE CONTROL OVERVIEW
The MC-12 remote control provides full operation of the MC-12,
performing commands such as menu navigation that are not
available from the front panel. The command matrix that begins
on page 2-14 indicates the commands remote control buttons
perform when each command bank is activated. The numbered
items in the matrix correspond with the remote control illustrations
on pages 2-14 to 2-18.
OPERATION CONSIDERATIONS
The bulleted items that begin below describe factors that can
improve or impede remote control operation. It is recommended
to observe these items as well as the battery installation instructions
on page 1-5 before operating the remote control.
Please note the following before operating the MC-12 remote
control:
• When the MC-12 is not using the rear panel IR IN connector,
the remote control must be in line-of-sight with the front panel
IR receiver for proper operation. Eliminate obstructions
between the remote control and the IR receiver. The remote
control might become unreliable if strong sunlight or
fluorescent light is shining on the IR receiver.
• For optimal performance, position the remote control at a 30
degree angle no more than 17 feet (5m) from the MC-12. If
the MC-12 is placed inside a glass cabinet, smoked glass will
reduce the remote control range.
• Remote controllers for different components can interfere with
one another. It is recommended to avoid using remote controls
for different components at the same time.
• The remote control batteries should be replaced as needed.
- Digital Controller 1
- IMPORTANT SAFETY INSTRUCTIONS 2
- Introduction 10
- Getting Started 13
- Basic Operation 18
- LOCK OPTIONS 45
- INPUT SETUP 45
- CHANGING INPUT NAMES 46
- EDIT INPUT NAME 46
- RESTORE DEFAULT NAME 47
- DIGITAL INDVD1INPUTSSETUP 48
- ANALOG INDVD1INPUTSSETUP 49
- AUTO ON, OFF 51
- MANUAL -18 to +12dB 51
- AUTO GAIN 51
- LEVEL METERS 51
- COMPONENT IN COMPONENT-1 to 4 52
- @*DDVD1INPUTSSETUP 55
- 5.1aDVD1INPUTSSETUP 55
- @@@!DVD1INPUTSSETUP 55
- MAIN ADVANCED 56
- ANALOG BYPASS ON, OFF 57
- S-VIDEO 16:9 AUTO, OFF 57
- (continued from page 3-15) 58
- (continued from page 3-17) 60
- RECORD ADVANCED 61
- (continued from page 3-19) 62
- SPEAKER SETUP 63
- SETTING CROSSOVER POINTS 63
- Custom Speaker Setups 64
- THX Speaker Setups 66
- THX SETUP Menu 67
- CUSTOM SETUP Menu 67
- Speaker Setup Parameters 67
- (continued from page 3-25) 68
- (continued from page 3-27) 70
- SUB L/R MONO, STEREO, NONE 71
- LFE ON, OFF 72
- ULTRA2 SUB ON, OFF 73
- (continued from page 3-31) 74
- Output Level Settings 75
- Speaker Distance Settings 75
- UNITS FEET, METERS 75
- AUTOMATIC CALIBRATION 76
- MAIN AUDIO OU 77
- (continued from page 3-41) 84
- (continued from page 3-43) 86
- MANUAL CALIBRATION 93
- INTERNAL NOISE TEST 96
- EXTERNAL NOISE TEST 97
- SETTING BASS PEAK LIMITERS 98
- CAL NOISE ON, OFF 99
- L/R LIMITER ON, OFF 99
- L/R LIMIT ADJ 75 to 120dB 99
- LFE LIMITER ON, OFF 99
- LFE LIMIT ADJ 75 to 120dB 99
- REAR PANEL CONFIG 100
- 8 STEREO INPUTS 100
- 5 STEREO & 5.1 ANLG 100
- DISPLAY SETUP 101
- A/V SYNC DELAY OFF, 1 to 60ms 101
- CUSTOM NAME ON, OFF 101
- EDIT CUSTOM NAME 102
- ON-SCREEN DISPLAY 103
- FRONT PANEL DISPLAY 105
- VOLUME CONTROL SETUP 106
- TRIGGER SETUP 107
- MODES LOCKED, UNLOCKED 109
- AUDIO CNTRL LOCKED, UNLOCKED 109
- SETUP LOCKED, UNLOCKED 109
- AUDIO CONTROLS 110
- MODE ADJUST 117
- Front Left Front Right 129
- TROUBLESHOOTING 160
- The MC-12 does not power on 160
- Dialog sounds muffled 160
- ROUTINE MAINTENANCE 162
- Appendix 164
- L C R SL SR SB LFE 170
- X X X XXX X 170
- (continued) 185
- & Buttons, 2-3, 5-4 188
- P (continued) 189
- R (continued) 189
- S (continued) 189
- LIMITED WARRANTY 193
- BUSINESS REPLY MAIL 194
Related products and manuals for AV receivers Lexicon MC-12
AV receivers Lexicon MC-12 User Manual
(208 pages)
(208 pages)
AV receivers Lexicon RV Receiver User Manual
(136 pages)
(136 pages)
Hoist Fitness CL-2103 manuali
Manuali dei proprietari e guide per l'utente per Fitness, palestra e allenamento per controllo del peso Hoist Fitness CL-2103.
We fornisce 1 manuali pdf Hoist Fitness CL-2103 per scaricare gratuitamente in base al tipo di documento: Manuale Utente
Comments to this Manuals