Lexicon CP-1 User Manual download pdf (Page 12)

Page 8

Lexicon

Connection

and

Calibration

VCR

CASSETTE DECK

AUDIO

OUT

TAPE

OUT/IN

REAR

MAIN

SIDE

AMPS

CP-1

INPUTS

VCR, TV, VIDEO

CONTROL CENTER

REAR

AMPS

CENTER

AMP

SUBWOOFER

AMP

CENTER

SUB

WOOFER

INTEGRATED AMP,

PREAMP or RECEIVER

TAPE

OUT

Connecting the CP-1

in a Tape Monitor Loop

Connect the main outputs of your audio preamplifier or the preamplifier

output of your receiver to Input I on the CP-1.

Inputs I and II are electrically identical and can be used interchangeably.

The CP-1 will also act as a line-level preamp with three inputs (including the

built-in tape monitor loop) if you wish to connect, for example, the audio

outputs from a TV receiver/monitor, a CD player and a VCR directly to it.

Connect the CP-1’s MAIN outputs to your main stereo channels. Connect

any additional amplifier/speaker combinations to the remaining outputs

on the CP-1: SIDE to the side amplifiers, REAR to the rears, CENTER to the

center- channel amplifier and SUB WOOFER to the subwoofer amp.

Locate the button below the SUB potentiometer marked CENTER/OUT,

PHANTOM/IN. If you have no center front speaker, push it in; if you have

a center channel, make sure this button is in the out position.

Audio Inputs

Note

Audio Outputs

If you have a receiver with no external access to the preamplifier outputs (or

you wish to use the tape monitor loop on your preamp), you can use a tape

output or external processor loop to the CP-1. However, any change in the

receiver’s volume control after the system is adjusted will upset the balance

between the main and auxiliary speakers. If you are using this configura-

tion, you should now turn the receiver’s volume control all the way down.

If there was a tape deck previously connected to your receiver's monitor

loop, connect it to the CP-1's tape outputs and inputs.

Note

Turn off ALL audio and video components, including individual power

amplifiers. (Unplug any preamps and power amps that don’t have

switches.) Locate the gain trim potentiometers on the CP-1 rear panel; these

are knobs at the top of the panel, marked REAR, SIDE, MAIN, CENTER and

SUB. Turn each one all the way down (counterclockwise as viewed from

the back).

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 57 58

Comments to this Manuals

No comments

Lexicon CP-1 User Manual Page 12

Comments to this Manuals