Lexicon CP-1 User Manual download pdf (Page 37)

Page 33

CP-1 Digital Audio Environment Processor

Troubleshooting

Problem Possible Cause and Solution

Restoring defaults If severe power surges or sags cause problems with CP-1 memory

storage, or you simply want to start with a clean slate in the User

registers, you can restore factory presets into the User registers

with the following procedure. This will erase any programs you

have stored in the User register, so you may want to note any

settings you wish to re-use before proceeding.

Turn CP-1 power OFF. While pressing PARAM on the Remote

Control, turn power ON. (Make sure your hand does not block the

infrared receiver on the CP-1 front panel.) Continue holding

down PARAM until the display reads:

** TEST MODE **

PRM Key To Exit

Release PARAM and press EFFECT MUTE to clear and reload

User registers, and to restore all factory settings of Volume,

Balance, Contrast, Configuration, etc. The display will read:

RESTORE DEFAULTS

Press PARAM to restore normal operation. (Remember to check

the LCD contrast and Configuration settings, since they will have

been reset to factory defaults.)

If you cannot solve functional problems through these proce-

dures, consult your dealer or Lexicon/Customer Service Depart-

ment. DO NOT, UNDER ANY CIRCUMSTANCES, OPEN THE

UNIT. DOING SO WILL VOID YOUR WARRANTY, AND

MODIFICATIONS MAY RENDER THE UNIT UNSERVICE-

ABLE.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 57 58

No comments

Lexicon CP-1 User Manual Page 37