Lexicon CP-1 User Manual download pdf (Page 35)

Page 31

CP-1 Digital Audio Environment Processor

Troubleshooting

If you encounter a problem, please review the items in the following

checklist. Also be sure to thoroughly check all other connected components

such as speakers, receiver/amplifier/preamp, VCR, TV, CD player, etc.

Problem Possible Cause and Solution

Input level meters not functioning Make sure INPUT LEVEL on the CP-1 front panel is turned up.

Check the connections on the rear and make sure signal is going

into the CP-1. Check SOURCE and MONITOR switches and try

toggling them in and out.

Make sure that the correct input is selected and that only one input

button is depressed.

Remote control not working Check the batteries and make sure that they are inserted correctly

with proper polarity. Make sure that the infrared receiver on the

CP-1 front panel above the POWER switch is not obstructed. If the

remote control unit is still not functioning, RESTORE DEFAULTS

as described below.

No audio Check input and output connections. They may be reversed

relative to the IN and OUT jacks of your receiver/amplifier/

preamp or other source.

Erratic behavior Power turn-on with large power amps may cause power sags that

will confuse the CP-1. To prevent this, plug the CP-1 into an AC

outlet on a different branch circuit, or turn on one amplifier at a

time.

No output First verify that signal is coming into the CP-1 by observing the

Input Level meters. Increase VOLUME using the Remote Control

and check the Front/Back and Left/Right balances.

Make sure that the rear panel Output Level controls are turned up.

Check the CP-1 mute controls to make sure they are not engaged.

Check all other equipment settings and connections and verify

that the amplifier(s) being fed by the CP-1 are operational.

Display irregularities Adjust the contrast (relative brightness) of the display using the

procedure described on the Quick Reference Guide, and on Page

13 of the Owner's Manual. If the display is showing strange

characters, RESTORE DEFAULTS as describet the end of this

section.

Center channel only plays Check to see if your HiFi VCR has dropped out of tracking —

readjust.

Your VCR Stereo/Mono/L-R switch may be in the wrong posi-

tion — set it to stereo.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 57 58

No comments

Lexicon CP-1 User Manual Page 35