Lexicon CP-1 User Manual Page 17

  • Download
  • Add to my manuals
  • Print
  • Page
    / 58
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 16
Page 13
CP-1 Digital Audio Environment Processor
Speaker
Set-Up and
Configuration
Configuration
Speaker Configurations
3
Press the PARAM UP or DOWN buttons until the contrast of the display is
at a maximum as seen from your listening chair. Then push PARAM to
enter the Configuration menu. Consulting the Speaker Configuration
Chart, push PARAM UP or DOWN until the figure and the description in
the display match your room.
Choose the diagram from the Speaker Configuration Chart that corre-
sponds to your room and note its number. Press the BANK button and hold
it for a few seconds. The display will read: LCD CONTRAST ADJ with a
bright bar. The CP-1 is now in Configuration mode. Within this mode,
operations are carried out using only the three PARAM buttons. Configu-
ration mode will be canceled if any other button is pressed or if 10 seconds
pass without a button push.
Subwoofers are not shown in any of these
configurations. Consult the subwoofer
owner's manual or your dealer for proper
placement of subwoofers, remembering
that corners are almost always best.
Side and rear speakers may sound better if
mounted above the listener, (See Page 15.)
1
Center Phantom
Button IN
3
Center Phantom
Button IN
4
Center Phantom
Button IN
2
Center Phantom
Button IN
5
8
7
10 11 12
Center Phantom
Button IN
9
Center Phantom
Button IN
6
speaker connected to
center output
speakers connected to
Main outputs
speakers connected to
Side outputs
speakers connected to
Rear outputs
Note: If you are using only one rear
speaker it may be hooked up to either
the left or right rear output, as long
as you use the correct Configuration
number.
Page view 16
1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 57 58

Comments to this Manuals

No comments